Mister Soaker Hose .820 x 100' Soaker Hose (Pro Green Stripe)
SKU: MDR-353
This item is not eligible for free shipping. Our shipping specialists will contact you with a detailed quote after ordering.
Helpful Tips & Guidelines:
- Always use compression fittings that fit over the hose/tubing as barb fittings that fit inside tend to diminish the flow rate.
- For even watering, individual lengths of soaker hose should not exceed 100' in length. Creating a system where a "loop" is created provides for more even water coverage.
- Soil type affects the amount of area the the soaker hose will water:
- Use soaker hose on top of the ground surface or covered with a layer of mulch for best results. You may bury the hose up to 4" deep is you wish, but this can make it more difficult to monitor watering, and lead to damage from roots or digging.
- A filter is highly recommended (Use a 200 mesh filter). For use on a well system, a filter is a MUST so that particles that might clog the pores of the tubing will be filtered out. Well water typically has particles of sediment in suspension. Installing a back flow preventer is highly recommended to stop dirty water backing up through the hose into your household drinking water supply. This is simply a matter of installing a one way valve between the water source or spigot and the first length of hose.
- For even watering, lay out soaker hose horizontally in sloped beds rather than up and down the hill.
- Water in the morning for maximum water efficiency & plant benefit.
- Watering deeply three times per week is a good rule of thumb.
- Soaker hose works best at low pressure. Use a soaker hose pressure regulator to control maximum water pressure.
- To prevent drinking water contamination use a backflow preventer
- Don't forget soaker hose is low flow, low pressure. Turn faucet on approximately 1/2 turn. If your hose "sprays" and doesn't weep, you have too much pressure.
- Specs for Deluxe Soaker Hose: inside diameter .500, outside diameter .700, wall thickness .100.
- GPH, is approx. 142.5 gallons per hour, per 100' at 25 psi, depending on inlet pressure, water hardness.
- Running lengths shorter than 50' will increase water flow, as lengths over 150' will decrease water flow.
- Soaker hose pressure regulator is mandatory. Burst strength is 80 PSI. DO NOT use soaker hose with normal house pressure. Maximum run per MrSoakerhose Deluxe Soaker is 150' per length with a maximum of 500' per faucet (water source) at one time. Soaker should be used on flat surfaces not exceeding a 2' rise over 100'.
Mr Soaker Hose | ||||
Item # | ˜ | Flow | Pressure | Flow Rate 20 GPH |
MDR/402 | 1/4? | .4 GPH per 1ft | 25 PSI | 15 Ft. Max. Run |
MDR/250 | 1/2? | 142 GPH per 100ft. | 25 PSI | 150 Ft. Max. Run |
MDR/350 | 5/8? | 224 GPH per 100ft. | 25 PSI | 250 Ft. Max. Run |